I&DT Project| Innovation in the Moulds and Plastics Sector

I&DT Project| Innovation in the Moulds and Plastics Sector

27/09/2016

I&DT Project | Innovation in the Moulds and Plastics Sector
Moldes RP developed, in partnership with Stream Consulting and ESTG - Leiria, the innovative system 2M - Blow - Two Material Injection and Gas Assisted Blowing, in a Investigation and Technological Development Project.
A scientific article (A New Manufacturing Process 2M-BLOW to Support the Integration of Bi-material Injection and Blowing Gas) with the main results of the project and developed by 3 partners, was now accepted for presentation in PMI 2016 - International Conference on Polymers and Moulds Innovations to take place in Ghent, Belgium, in September 2016.
 

Voltar
Other News

Moldes RP_Plastpol - 2016

Moldes RP attended Plastpol Fair, in Poland, during the days 17th-20th of May, 2016.https://www.youtube.com/watch?v=-Tn0CFjsyP4
Read more

Industry 4.0

Moldes RP in the cover of the magazine “The Mold”. With the collaboration of many experts and knowledge centers in this area, we discuss the trends and challenges of the "Industry...
Read more

Moldes RP_Manufactura de Autopartes_2016

Moldes RP attended to “Manufactura de Autopartes” Fair between the days 23 – 25 of August, in Queretaro, Mexico.
Read more

Moldes RP_Moulding Expo

Moldes RP attended to "Moulding Expo" fair in Stuttgart, Germany, during the days 30th of May and 2nd of June, 2017. 
Read more